CALCulate Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.424 E-11
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S1IFoffset:UPPer?
This command performs an upper limit check for the frequency offset of the sound carrier 1.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S1IF:UPP 10KHZ
Sets the upper frequency offset limit for sound carrier 1 to 10 kHz.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:S1IF:UPP?
Performs an upper limit check for the frequency offset of the sound carrier 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S1PRelative:LOWer?
This command performs a lower limit check for the relative power of the sound carrier 1.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S1PR:LOW –10
Sets the relative lower power limit for sound carrier 1 to –10 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:S1PR:LOW?
Performs a lower limit check for the relative power of the sound carrier 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
To Next Page
Loading...
