R&S FSL CALCulate Subsystem (CATV, K20)
1300.2519.12 6.425 E-11
C
ALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S1PRelative:UPPer?
This command performs an upper limit check for the relative power of the sound carrier 1.
T
he numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S1PR:UPP 20
Sets the relative lower power limit for sound carrier 1 to 20 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:S1PR:UPP?
Performs an upper limit check for the relative power of the sound carrier 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S2IFoffset:LOWer?
This command performs a lower limit check for the frequency offset of the sound carrier 2.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S2IF:LOW 1KHZ
Sets the lower frequency offset limit for sound carrier 2 to 1 kHz.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:S2IF:LOW?
Performs a lower limit check for the frequency offset of the sound carrier 2.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S2IFoffset:UPPer?
This command performs an upper limit check for the frequency offset limit of the sound carrier 2.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S2IF:UPP 500000HZ
Sets the upper frequency offset limit for sound carrier 2 to 500 kHz.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
To Next Page
Loading...
