Rohde & Schwarz R&S FSL3 - Page 1185

CALCulate Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.426 E-11
CALC:ATV:LIM:RES:CARR:S2IF:UPP?
Performs an upper limit check for the frequency offset limit of the sound carrier 2.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S2PRelative:LOWer?
This command performs a lower limit check for the relative power of the sound carrier 2.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S2PR:LOW –20
Sets the relative lower power limit for sound carrier 2 to –20 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:S2PR:LOW?
Performs a lower limit check for the relative power of the sound carrier 2.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:S2PRelative:UPPer?
This command performs an upper limit check for the relative power of the sound carrier 2.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:S2PR:UPP –14
Sets the relative lower power limit for sound carrier 2 to –14 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:S2PR:UPP?
Performs an upper limit check for the relative power of the sound carrier 2.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV