Rohde & Schwarz R&S FSL3 - Page 1186

R&S FSL CALCulate Subsystem (CATV, K20)
1300.2519.12 6.427 E-11
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:VCFoffset:LOWer?
This command performs a lower limit check for the frequency offset of the vision carrier.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:VCF:LOW –1KHZ
Sets the lower frequency offset limit of the vision carrier to –1 kHz.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:VCF:LOW?
Performs a lower limit check for the frequency offset of the vision carrier.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:VCFoffset:UPPer?
This command performs an upper limit check for the frequency offset of the vision carrier.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:VCF:UPP 1KHZ
Sets the upper frequency offset limit of the vision carrier to 1 kHz.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:VCF:UPP?
Performs an upper limit check for the frequency offset of the vision carrier.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:VCPabsolute:LOWer?
This command performs a lower limit check for the absolute vision carrier power.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:VCP:LOW –40
Sets the absolute lower limit of the vision carrier to –40 dBm.
INIT;*WAI
Starts a new measurement and waits for the sweep end.