CALCulate Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.428 E-11
CALC:ATV:LIM:RES:CARR:VCP:LOW?
Performs a lower limit check for the absolute vision carrier power.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CARRiers:VCPabsolute:UPPer?
This command performs an upper limit check for the absolute vision carrier power.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CARR:VCP:UPP –20
Sets the absolute lower limit of the vision carrier to –20 dBm.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CARR:VCP:UPP?
Performs an upper limit check for the absolute vision carrier power.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CN:CN[:LOWer]?
This command performs a lower limit check for the carrier–to–noise ratio.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CN:CN 10
Sets the lower limit of the carrier–to–noise ratio to 10 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CN:CN?
Performs a lower limit check for the carrier–to–noise ratio.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
To Next Page
Loading...
