Rohde & Schwarz R&S FSL3 - Page 1188

R&S FSL CALCulate Subsystem (CATV, K20)
1300.2519.12 6.429 E-11
CALCulate<1|2>:ATV:LIMit:RESult:CSO:CSO[:LOWer]?
This command performs a lower limit check for the carrier–to–second order beat ratio.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CSO:CSO 10
Sets the lower limit of the carrier–to–second order beat ratio to 10 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CSO:CSO?
Performs a lower limit check for the carrier–to–second order beat ratio.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:CTB:CTB[:LOWer]?
This command performs a lower limit check for the carrier–to–composite triple beat ratio.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:CTB:CTB 10
Sets the lower limit of the carrier–to–second order beat ratio to 10 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:ATV:LIM:RES:CTB:CTB?
Performs a lower limit check for the carrier–to–composite triple beat ratio.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate<1|2>:ATV:LIMit:RESult:HUM:HUM:LOWer?
This command performs a lower limit check for the Hum measurement.
The numeric suffixes <1|2> are irrelevant.
This command is a query and therefore has no *RST value.
Example
CALC:ATV:LIM:HUM:HUM:LOW 10
Sets the lower limit for the hum values to 10 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.