Rohde & Schwarz R&S FSL3 - Page 1216

R&S FSL CALCulate Subsystem (CATV, K20)
1300.2519.12 6.457 E-11
CALCulate:DTV:LIMit:RESult:QERRor:UPPer?
This command performs an upper limit check for the quadrature error in the Modulation Errors
measurement.
This command is a query and therefore has no *RST value.
Example
CALC:DTV:LIM:QERR:UPP 20
Sets the upper limit for the quadrature error to 20 deg.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:DTV:LIM:RES:QERR:UPP?
Performs an upper limit check for the quadrature error.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate:DTV:LIMit:RESult:SROFfset:LOWer?
This command performs a lower limit check for the symbol rate offset in the Overview
measurement.
This command is a query and therefore has no *RST value.
Example
CALC:DTV:LIM:SROF:LOW –5000
Sets the lower limit for the symbol rate offset to –5000 symb/s.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:DTV:LIM:RES:SROF:LOW?
Performs a lower limit check for the symbol rate offset.
Characteristics
RST value: –10000
SCPI: device–specific
Mode
CATV