Rohde & Schwarz R&S FSL3 - Page 1266

R&S FSL SENSe Subsystem (CATV, K20)
1300.2519.12 6.507 E-11
[
SENSe<1|2>:]TV:MSTandard:STYPe
This command defines the signal type of a modulation standard.
T
he numeric suffixes <1|2> are irrelevant.
Parameter
ATV | DTV
Example
TV:MST:STYP DTV
Sets the signal type DTV.
Characteristics
RST value: ATV
SCPI: device–specific
Mode
CATV
[SENSe<1|2>:]TV:TILT:MSTandard:CDISable
This command deactivates a modulation standard for the Tilt measurement.
The numeric suffixes <1|2> are irrelevant.
Parameter
<string>: modulation standard name
Example
CONF:TV:CTAB:SEL 'TV–ITALY'
Activates the channel table TV–ITALY.
CONF:TV:MEAS TILT
Configures the R&S FSL to measure the channel power of every channel.
TV:TILT:MST:CDIS 'PAL BG ITALY'
Deactivates the modulation standard PAL BG ITALY.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV