Rohde & Schwarz R&S FSL3 - Page 1265

SENSe Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.506 E-11
SENSe:TV Subsystem (CATV, K20)
The SENSe:DDEMod subsystem controls the TV settings.
Commands of the SENSe:TV Subsystem
– [SENSe<1|2>:]TV:MSTandard:FILTer:GDELay
– [SENSe<1|2>:]TV:MSTandard:NAME
– [SENSe<1|2>:]TV:MSTandard:STYPe
– [SENSe<1|2>:]TV:TILT:MSTandard:CDISable
– [SENSe<1|2>:]TV:TILT:MSTandard:CENable
[SENSe<1|2>:]TV:MSTandard:FILTer:GDELay
This command defines the group delay for a modulation standard.
The numeric suffixes <1|2> are irrelevant.
Parameter
GENeral | GHALf | AUSTralia | DANMark | NEWZealand | NORWay | SWEDenfull | FLAT |
OIRT | CHINa | CCIR | TDF | FFC
Example
TV:MST:FILT:GDEL FLAT
Sets the group delay FLAT.
Characteristics
RST value: GENERAL
SCPI: device–specific
Mode
CATV
[SENSe<1|2>:]TV:MSTandard:NAME
This command defines the name for a modulation standard.
The numeric suffixes <1|2> are irrelevant.
Parameter
<string>: 1 to 15 characters
Example
TV:MST:NAME 'TEST'
Gives the modulation standard the name 'TEST'.
Characteristics
RST value: Analog TV
SCPI: device–specific
Mode
CATV