Rohde & Schwarz R&S FSL3 - Page 1264

R&S FSL SENSe Subsystem (CATV, K20)
1300.2519.12 6.505 E-11
SENSe:SWEep Subsystem (CATV, K20)
The SENSe:SWEep subsystem controls the sweep parameters.
Commands of the SENSe:SWEep Subsystem
– [SENSe<1|2>:]SWEep:COUNt
– [SENSe<1|2>:]SWEep:POINts
– [SENSe<1|2>:]SWEep:SPACing
– [SENSe<1|2>:]SWEep:TIME
– [SENSe<1|2>:]SWEep:TIME:AUTO
[SENSe<1|2>:]SWEep:COUNt
For details refer to "[SENSe<1|2>:]SWEep:COUNt" on page 6.229.
[SENSe<1|2>:]SWEep:POINts
For details refer to "[SENSe<1|2>:]SWEep:POINts" on page 6.233.
[SENSe<1|2>:]SWEep:SPACing
This command defines the labeling of the frequency axis. For details refer to chapter
"Instrument Functions", section "Cable TV Measurement Option (K20)", Frequency Abs/Rel
softkey.
The numeric suffixes <1|2> are irrelevant.
Parameter
ABSolute | RELative
Example
SWE:SPAC ABS
Sets absolute labeling of the frequency axis.
Characteristics
RST value: REL
SCPI: device–specific
Mode
CATV
[SENSe<1|2>:]SWEep:TIME
For details refer to "[SENSe<1|2>:]SWEep:TIME" on page 6.234.
[SENSe<1|2>:]SWEep:TIME:AUTO
For details refer to "[SENSe<1|2>:]SWEep:TIME:AUTO" on page 6.234.