Rohde & Schwarz R&S FSL3 - Page 1328

R&S FSL CALCulate Subsystem (WCDMA, K72)
1300.2519.12 6.569 E-11
CALCulate:FEED Subsystem (WCDMA, K72)
The CALCulate:FEED subsystem selects the evaluation method of the measured code domain power
data. This corresponds to the selection of the result display in manual mode.
Commands of the CALCulate:FEED Subsystem
– CALCulate<1|2>:FEED
CALCulate<1|2>:FEED
This command selects the result display for the Code Domain Power Diagram measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
Result display Display format
XPOWer:CDP Code Domain Power Diagram
in relative scaling
bar graph
XPOWer:CDP:ABSolute Code Domain Power Diagram
in absolute scaling
bar graph
XTIMe:CDPower:ERRor:CTABle Code Domain Channel Table channel assignment table
XTIMe:CDPower:ERRor:SUMMary Code Domain Result Summary
(default setting)
results in table format
Example
CALC:FEED 'XPOW:CDP'
Selects the Code Domain Power Diagram result display in absolute scaling.
Characteristics
RST value: –
SCPI: conform
Mode
WCDMA