Rohde & Schwarz R&S FSL3 - Page 1329

CALCulate Subsystem (WCDMA, K72) R&S FSL
1300.2519.12 6.570 E-11
CALCulate:LIMit:ESPectrum (WCDMA, K72)
The CALCulate:LIMit:ESPectrum subsystem defines limit checking for RF measurements.
Commands of the CALCulate:LIMit:ESPectrum Subsystem
– CALCulate<1|2>:LIMit<1...8>:ESPectrum:MODE
– CALCulate<1|2>:LIMit<1...8>:ESPectrum:RESTore
– CALCulate<1|2>:LIMit<1...8>:ESPectrum:TRANsition
– CALCulate<1|2>:LIMit<1...8>:ESPectrum:VALue
CALCulate<1|2>:LIMit<1...8>:ESPectrum:MODE
This command activates or deactivates automatic selection of the limit line in the spectrum
emission mask measurement.
The numeric suffixes <1|2> and <1...8> are irrelevant for this command.
Parameter
AUTO Sets the limit line automatically according to the power determined in the useful
channel.
MANual Activates the selected predefined limit lines.
The selection is made with the
CALCulate<1|2>:LIMit<1...8>:ESPectrum:VALue command.
USER Activates the user–defined limit lines.
(for details refer to "Using Limit Lines and Display Lines – LINES Key").
Example
CONF:WCDP:MEAS ESP
Selects the spectrum emission mask measurement.
CALC:LIM:ESP:MODE MAN
Activates the selected predefined limit lines.
Characteristics
RST value: AUTO
SCPI: device–specific
Mode
WCDMA
CALCulate<1|2>:LIMit<1...8>:ESPectrum:RESTore
This command restores the predefined limit lines for the spectrum emission mask
measurement. All modifications made to the predefined limit lines are lost and the factory–set
values are restored.
The numeric suffixes <1|2> and <1...8> are irrelevant for this command.
This command is an event and therefore has no *RST value and no query.
Example
CONF:WCDP:MEAS ESP
Selects the spectrum emission mask measurement.
CALC:LIM:ESP:REST
Sets the spectrum emission mask limit lines back to the factory–set values.