Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.602 E-11
Example
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
INIT;*WAI
Starts measurement with synchronization.
CALC:MARK:FUNC:PICH
Activates marker and positions it at pilot 0.64.
CALC:MARK:Y?
Queries value of the relative Code Domain Power of the pilot channel.
Characteristics
RST value: -
SCPI: device-specific
Mode
CDMA
CALCulate<1|2>:MARKer<1...4>:FUNCtion:TDPIch
This command sets the marker 1 to channel 16.128.
The numeric suffix at CALCulate<1|2> specifies the measurement window. The numeric suffix
at MARKer<1...4> specifies the marker to be set to the pilot channel.
This command is an event and therefore has no *RST value and no query.
Example
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
CDP:ANT 2
Selects antenna 2.
CDP:SFAC 128
Selects base spreading factor 128.
INIT;*WAI
Starts measurement with synchronization.
CALC:MARK:FUNC:TDPI
Activates marker and positions it at TDPICH 16.128.
CALC:MARK:Y?
Queries value of the relative Code Domain Power of the transmit diversity pilot channel.
Characteristics
RST value: -
SCPI: device-specific
Mode
CDMA
To Next Page
Loading...
