Rohde & Schwarz R&S FSL3 - Page 1379

Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.620 E-11
E
xample
I
NST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
CDP:PREF TOT
S
ets total power as reference power.
INIT;*WAI
Starts measurement with synchronization.
Characteristics
RST value: PICH
SCPI: device-specific
Mode
CDMA
[SENSe<1|2>:]CDPower:QINVert
This command inverts the sign of the Q–component of the signal.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
ON | OFF
Example
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
CDP:QINV ON
Activates the inversion of the Q–component sign.
INIT;*WAI
Starts measurement with synchronization.
Characteristics
RST value: OFF
SCPI: device-specific
Mode
CDMA
[SENSe<1|2>:]CDPower:SFACtor
This command defines the base spreading factor. If the base spreading factor of 64 is used for
channels of spreading factor 128 (code class 7), an alias power is displayed in the Code
Domain Power and Code Domain Error Power diagrams.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
64 | 128