Rohde & Schwarz R&S FSL3 - Page 1378

R&S FSL SENSe Subsystem (CDMA, K82)
1300.2519.12 6.619 E-11
CDP:ORD BITR
Sets BitReverse order.
TRAC? TRACE2
Reads out the results in BitReverse order.
Characteristics
RST value: HADamard
SCPI: device-specific
Mode
CDMA
[SENSe<1|2>:]CDPower:PNOFfset
This command sets the PN offset of the base station in multiples of 64 chips.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
0 to 511
Example
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
CDP:PNOF 45
Sets PN offset.
INIT;*WAI
Starts measurement with synchronization.
Characteristics
RST value: 0
SCPI: device-specific
Mode
CDMA
[SENSe<1|2>:]CDPower:PREFerence
This command specifies the reference power for the relative power result displays (Code
Domain Power, Power vs PCG).
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
PICH The reference power is the power of the pilot channel. Which pilot channel is
used as reference depends on the antenna diversity (for details see
[SENSe<1|2>:]CDPower:ANTenna command).
TOTal The reference power is the total power of the signal referred per power control
group (PCG) to the corresponding PCG.
For further information refer to chapter 4, "Power Reference"