Rohde & Schwarz R&S FSL3 - Page 1374

R&S FSL SENSe Subsystem (CDMA, K82)
1300.2519.12 6.615 E-11
SENSe:CDPower Subsystem (CDMA, K82)
This subsystem sets the parameters for the code domain measurements mode. The numeric suffix at
SENSe<1|2> is irrelevant.
Commands of the SENSe:CDPower Subsystem
– [SENSe<1|2>:]CDPower:ANTenna
– [SENSe<1|2>:]CDPower:CODE
– [SENSe<1|2>:]CDPower:ICTReshold
– [SENSe<1|2>:]CDPower:IQLength
– [SENSe<1|2>:]CDPower:LEVel:ADJust
– [SENSe<1|2>:]CDPower:NORMalize
– [SENSe<1|2>:]CDPower:ORDer
– [SENSe<1|2>:]CDPower:PNOFfset
– [SENSe<1|2>:]CDPower:PREFerence
– [SENSe<1|2>:]CDPower:QINVert
– [SENSe<1|2>:]CDPower:SFACtor
– [SENSe<1|2>:]CDPower:SLOT
– [SENSe<1|2>:]CDPower:TPMeas
[SENSe<1|2>:]CDPower:ANTenna
This command deactivates the orthogonal transmit diversity (two–antenna system) or defines
the antenna for which the result display evaluated.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
OFF The aggregate signal from both antennas is fed in.
1 The signal of antenna 1 is fed in.
2 The signal of antenna 2 is fed in.
For further details refer to chapter 4, "Antenna Diversity".
Example
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
CDP:ANT 2
Selects antenna 2.
CDP:SFAC 128
Selects base spreading factor 128.
INIT;*WAI
Starts measurement with synchronization.
CALC:MARK:FUNC:PICH
Activates marker 1 and positions it at the transmit diversity pilot channel (TDPICH) 16.128.
CALC:MARK:Y?
Queries value of the relative Code Domain Power of the TDPICH.