Rohde & Schwarz R&S FSL3 - Page 1394

R&S FSL CALCulate Subsystem (EVDO, K84)
1300.2519.12 6.635 E-11
CALCulate:FEED Subsystem (EVDO, K84)
The CALCulate:FEED subsystem selects the type of evaluation for the measurement data. This
corresponds to the result display selection in manual operation.
Commands of the CALCulate:FEED Subsystem
– CALCulate<1|2>:FEED
CALCulate<1|2>:FEED
This command selects the result display for the measured data.The numeric suffix at
CALCulate<1|2> specifies the measurement window.
Parameter
XPOW:CDP Code Domain Power (CDP) result display (absolute)
XPOW:CDP:RAT Code Domain Power (CDP) result display (relative)
XPOW:CDEP Code Domain Error Power (CDEP) result display
XTIM:CDP:ERR:CTABle Channel Table result display
XTIM:CDP:PVChip Power vs Chip result display
XTIM:CDP:ERR:SUMM Result Summary result display
XTIM:CDP:MACCuracy Composite EVM result display
XTIM:CDP:ERR:PCDomain Peak Code Domain Error result display
XTIM:CDP:SYMB:CONSt Channel Constellation result display
XTIM:CDP:SYMB:EVM Symbol Error Vector Magnitude result display
XTIM:CDP:BSTReam Channel Bitstream result display
XTIM:CDP:COMP:CONSt Composite Constellation result display
XTIM:CDP:PVSYmbol Power versus Symbol result display
Example
CALC:FEED 'XTIM:CDP:MACC'
Selects the Composite EVM result display.
Characteristics
RST value: 'XPOW:CDP:RAT'
SCPI: device-specific
Mode
EVDO