R&S FSL TRACe Subsystem (1xEV-DO, K84)
1300.2519.12 6.665 E-11
T
RACe<1|2>[:DATA]? LIST
This command returns the peak list. For each peak the following entries are given:
<freq1>, <level1>, <delta level 1>, <freq2>, <level2>, <delta level 2>, ... <freq n>, <level n>,
<delta level n>
Parameter
LIST
Example
TRAC1:DATA? LIST
Peak list consist of Frequency of the peak, absolute level of the peak and distance to the limit
line
Characteristics
RST value: -
SCPI: device–specific
Mode
EVDO
TRACe<1|2>[:DATA]
The numeric suffixes <1|2> are irrelevant for this command except TRAC2? TRACe1 command
in this case the numeric suffix <2> is screen B.
Parameter for code domain power measurements
TRACE1 | TRACE2 Reads out the trace data of measurement window 1 or 2.
CTABle For the Channel Table result display, reads out the maximum values of the
timing/phase offset between every assigned channel and the pilot channel
(see also [SENSe<1|2>:]CDPower:TPMeas command).
Return values
The return values for each measurement are listed below:
– Code Domain Power
– General Results / Channel Results
– Power vs Chip
– Power vs Symbol
– Composite EVM
– Channel Table
– Bitstream
– Peak Code Domain Error
– Code Domain Error
– Symbol Constellation
– EVM vs Symbol
– Composite Constellation
– Return values for parameter CTABle
To Next Page
Loading...
