R&S FSL CALCulate:MARKer Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.693 E-11
CALCulate<1|2>:MARKer<1>:MAXimum
This command sets the selected marker to the maximum peak value in the current trace. This
command is only available for the Spectrum Flatness result display.
This command is an event and therefore has no *RST value and no query.
Example
CALC2:MARK:MAX
Set marker 1 in screen B to maximum value in trace.
Characteristics
RST value: –
SCPI: device–specific
Mode
WLAN
CALCulate<1|2>:MARKer<1>:MINimum
This command sets the selected marker to the minimum peak value in the current trace. This
command is only available for the Spectrum Flatnes result display.
This command is an event and therefore has no *RST value and no query.
Example
CALC2:MARK:MIN
Set marker 1 in screen B to minimum value in trace.
Characteristics
RST value: –
SCPI: device–specific
Mode
WLAN
CALCulate<1|2>:MARKer<1>:SYMBol
This command positions the selected marker to the indicated symbol.
This command is query only for the following result displays:
– Constellation vs Symbol
– Constellation vs Carrier
Parameter
<numeric_value>
Example
CALC:MARK:SYMB 2
Positions marker 1 to symbol 2.
CALC:MARK:SYMB?
Outputs the symbol value of marker 1.
To Next Page
Loading...
