Rohde & Schwarz R&S FSL3 - Page 1453

CALCulate:MARKer Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.694 E-11
C
haracteristics
*RST value: –
SCPI: device–specific
M
ode
WLAN
CALCulate<1|2>:MARKer<1>:TRACe
This command assigns the selected marker to the indicated measurement curve in the selected
measurement window.
This command is only available for the following result displays:
– Constellation versus Carrier
– EVM vs Symbol
– Frequency Error vs Preamble
– Phase Error vs Preamble
– PVT Full Burst
– PVT Rising / Falling
– Spectrum Flatness
– Spectrum Mask, if Max Hold trace is displayed
– Spectrum ACP/ACPR, if Max Hold trace is displayed
Example
"CALC2:MARK:TRAC 2
Assigns marker 1 in screen B to trace 2.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
WLAN
CALCulate<1|2>:MARKer<1>:X
This command positions the selected marker to the indicated inphase (Constellation vs
Symbol), frequency (Spectrum FFT, Spectrum Mask, Spectrum APCR), time (Magnitude
Capture Buffer, Auto level, PVT Full Burst, PVT Rising / Falling), power (CCDF), sub–carrier
(Constellation vs Carrier, EVM vs Carrier, Spectrum Flatness) or symbol (EVM vs Symbol) in
the selected measurement window.
This command is query only for the following result displays:
– Constellation vs Symbol
– Constellation vs Carrier
Parameter
<numeric_value> in Hz, s, dB
Example
CALC:MARK:X 2ms
Positions marker 1 to time 2ms.