Rohde & Schwarz R&S FSL3 - Page 1477

FETCh Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.718 E-11
FETCh:BURSt:PAYLoad?
This command returns the measured power in the payload of the burst.
This command is a query only and thus has no *RST value.
Example
FETC:BURS:PAYL?
The burst payload power is returned
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
FETCh:BURSt:PEAK?
This command returns the Peak power in dBm measured during the measurement time.
Example
FETC:BURS:PEAK?
The calculated peak power from the most recent measurement is returned.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
FETCh:BURSt:PREamble?
This command returns the measured power in the burst preamble.
This command is a query only and thus has no *RST value.
Example
FETC:BURS:PRE?
The burst preamble power is returned
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN