Rohde & Schwarz R&S FSL3 - Page 1528

R&S FSL CALCulate:LIMit Subsystem (WiMAX, K92/K93)
1300.2519.12 6.769 E-11
CALCulate<1|2>:LIMit<1...8>:BURSt:IQOFfset[:AVERage]:RESult?
This command returns the average IQ offset error limit result.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
T
his command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
Example
CALC:LIM:BURS:IQOF:RES?
Average IQ offset error limit result is returned.
Characteristics
*RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:IQOFfset:MAXimum
This command sets the maximum IQ offset error limit.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
–1000000 to 1000000 dB or %
If no unit is specified the unit specified by the UNIT:TABLe command is used.
Example
CALC:LIM:BURS:IQOF:MAX 15.0DB
Maximum IQ offset error limit is set to 15.0 dB.
Characteristics
*RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:IQOFfset:MAXimum:RESult?
This command returns the maximum IQ offset error limit result.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED