Rohde & Schwarz R&S FSL3 - Page 1530

R&S FSL CALCulate:LIMit Subsystem (WiMAX, K92/K93)
1300.2519.12 6.771 E-11
CALCulate<1|2>:LIMit<1...8>:BURSt:SSTiming:MAXimum
This command is only supported for reasons of compatibility with the FSP family. It sets the
maximum Subscriber Station Timing limit.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
0PCT
Example
CALC:LIM:BURS:SST:MAX?
Maximum SS Timing limit is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:SSTiming:MAXimum:RESult?
This command returns the maximum Subscriber Station Timing limit.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
Example
CALC:LIM:BURS:SST:MAX:RES?
Maximum SS Timing limit result is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:SYMBolerror[:AVERage]
This command sets the average symbol error limit.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
<numeric_value> in ppm or %: –1000000 to 1000000
If no unit is specified the unit depends on the current Up/Down Link Mode: ppm in Down Link
mode, % in Up Link mode.
Note: There is no relationship between the Down Link and Up Link values. Setting a Down
Link value in Up Link mode does not change the displayed limit value.