CALCulate:LIMit Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.772 E-11
Example
CALC:LIM:BURS:SYMB 10000
The average symbol error limit is set to 10000 Hz.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:SYMBolerror[:AVERage]:RESult?
This command returns the average symbol error limit result.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
Example
CALC:LIM:BURS:SYMB:RES?
Average symbol error limit result is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:SYMBolerror:MAXimum
This command sets the maximum symbol error limit.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
<numeric_value> in ppm or %: –1000000 to 1000000
If no unit is specified the unit depends on the current Up/Down Link Mode: ppm in Down Link
mode, % in Up Link mode.
Note: There is no relationship between the Down Link and Up Link values. Setting a Down
Link value in Up Link mode does not change the displayed limit value.
Example
CALC:LIM:BURS:SYMB:MAX?
Maximum symbol error limit is returned.
To Next Page
Loading...
