R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.785 E-11
C
ONFigure:BURSt:BSTReam:BURSt:SELect
This command selects bursts and pilots. It is only available if the Bitstream measurement is
selected (see CONFigure:BURSt:STATistics:BSTReam[:IMMediate] command). (K93)
P
arameter
0 to 9999 burst number
ALL all bursts
PILOTS only pilots
Example
CONF:BURS:STAT:BSTR
Configures the Bitstream measurement type.
CONF:BURS:BSTR:BURS:SEL 1
Selects burst 1.
INIT
Starts a Bitstream measurement. The results of the selected burst (1) are calculated.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:BURSt:BSTReam:FORMat:SELect
This command selects the modulation format. It is only available if the Bitstream measurement
is selected (see CONFigure:BURSt:STATistics:BSTReam[:IMMediate] command).
Parameter
ALL |QPSK | QAM16 | QAM64
Example
CONF:BURS:STAT:BSTR
Configures the Bitstream measurement type.
CONF:BURS:BSTR:FORM:SEL QPSK
Selects the QPSK modulation formats.
INIT
Starts a Bitstream measurement. The results of the selected modulation formats (QPSK) are
calculated.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
