CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.786 E-11
C
ONFigure:BURSt:BSTReam:SYMBol:SELect
This command selects the symbol. It is only available if the Bitstream measurement is selected
(see CONFigure:BURSt:STATistics:BSTReam[:IMMediate] command).
P
arameter
0 to 9999 symbol number
ALL all symbols
Example
CONF:BURS:STAT:BSTR
Configures the Bitstream measurement type.
CONF:BURS:BSTR:SYMB:SEL 1
Selects symbol 1.
INIT
Starts a Bitstream measurement. The results of the selected symbol (1) are calculated.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:BURSt:CONSt:BURSt:SELect
This command selects bursts and pilots. It is only available if the Constellation vs Symbol
measurement is selected (see CONFigure:BURSt:CONSt:CSYMbol[:IMMediate]
command).
Parameter
0 to 9999 burst number
ALL all bursts
PILOTS only pilots
Example
CONF:BURS:CONS:CSYM
Configures the Constellation vs Symbol measurement type.
CONF:BURS:CONS:BURS:SEL 1
Selects burst 1.
INIT
Starts a Constellation vs Symbol measurement. The results of the selected burst (1) are
calculated.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
