Rohde & Schwarz R&S FSL3 - Page 1551

CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.792 E-11
C
ONFigure:BURSt:SPECtrum:ACPR[:IMMediate]
This command configures the ACPR (adjacent channel power relative) measurement type.
T
his command is an event and therefore has no *RST value and no query.
Example
CONF:BURS:SPEC:ACPR
Configures the ACPR measurement type.
INIT
Starts an ACPR measurement.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:SPECtrum:ACPR:SELect
This command specifies the type of ACP measurement to be performed.
Parameter
ABSolute | RELative
Example
CONF:BURS:SPEC:ACPR:SEL ABS
Specifies the ACP measurement type absolute.
Characteristics
RST value: REL
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:SPECtrum:FFT[:IMMediate]
This command configures the FFT (Fast Fourier Transform) measurement type.
This command is an event and therefore has no *RST value and no query.
Example
CONF:BURS:SPEC:FFT
Configures the FFT measurement type.
INIT
Starts an FFT measurement.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro