R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.793 E-11
CONFigure:BURSt:SPECtrum:FLATness[:IMMediate]
This command configures the Spectrum Flatness measurement type. For settings for the
Spectrum Flatness measurement see CONFigure:BURSt:SPECtrum:FLATness:SELect
command.
This command is an event and therefore has no *RST value and no query.
Example
CONF:BURS:SPEC:FLAT
Configures the Spectrum Flatness measurement type.
INIT
Starts a Spectrum Flatness measurement.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:SPECtrum:FLATness:SELect
This command configures the interpretation of the Spectrum Flatness measurement results.
Parameter
FLATness spectrum flatness
GRDelay group delay
DIFFerence flatness difference
Example
CONF:BURS:SPEC:FLAT
Configures the Spectrum Flatness measurement type.
CONF:BURS:SPEC:FLAT:SEL GRD
Configures the group delay for the Spectrum Flatness measurement.
Characteristics
RST value: FLAT
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:SPECtrum:MASK[:IMMediate]
This command configures the Spectrum Mask measurement type. For settings for the Spectrum
Mask measurement see CONFigure:BURSt:SPECtrum:MASK:SELect command.
This command is an event and therefore has no *RST value and no query.
Example
CONF:BURS:SPEC:MASK
Configures the Spectrum Mask measurement type.
INIT
Starts a Spectrum Mask measurement.
To Next Page
Loading...
