CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.796 E-11
CONFigure:POWer:AUTO
This command switches on or off the automatic power level detection.
Parameter
ON | OFF | ONCE
Example
CONF:POW:AUTO ON
At the start of every measurement sweep the input power level is detected automatically.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:POWer:AUTO:SWEep:TIME
This command specifies the sweep time for the automatic power level detection.
Parameter
1ms to 1s
Example
CONF:POW:AUTO ON
At the start of every measurement sweep the input power level is detected automatically.
CONF:POW:AUTO:SWE:TIME 200MS
The sweep time is set to 200 ms power level.
Characteristics
RST value: 100 ms
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:POWer:EXPected:RF
This command specifies the input power level of the source signal that will be supplied at the
analyzer RF input.
Parameter
–999.99 dBm to 999.99 dBm
Example
CONF:POW:EXP:RF –20
Assumes an input signal strength of –20 dBm.
Characteristics
RST value: –30 dBm
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
