R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.797 E-11
CONFigure:STANdard
This command specifies the Wireless LAN standard to be measured.
Parameter
0 IEEE 802.16–2004 OFDM
1 IEEE 802.16e–2005 OFDMA
2 IEEE 802.16e–2005 WiBro
Example
CONF:STAN 0
The measurements will be performed according to IEEE 802.16–2004.
Characteristics
RST value: 1
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:WIMax:AVERaging
This command specifies the RSSI, CINR averaging parameter.
Parameter
0.000001 to 0.999999
Example
CONF:WIM:AVER 0.1
Sets the value to 0.1
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:DLSFrame:IDCell
This command specifies the downlink IDCell number. The downlink IDCell number is used as
DL_PermBase parameter for the permutation equations to partly set the sub carrier randomizer
initialization vector.
Parameter
0 to 31
Example
CONF:WIM:DLSF:IDC 0
Sets the downlink IDCell number to 0.
To Next Page
Loading...
