Rohde & Schwarz R&S FSL3 - Page 1557

CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.798 E-11
C
haracteristics
RST value: 0
SCPI: device–specific
M
ode
OFDMA/WiBro
CONFigure:WIMax:DLSFrame:PREamble:MODE
This command specifies how the preamble index is calculated.
Parameter
AUTO The preamble index is automatically calculated according to the parameters set by
the CONFigure:WIMax:DLSFrame:IDCell and
CONFigure:WIMax:DLSFrame:SEGMent<1…3> commands.
USER The preamble index can be specified manually, i.e. the preamble pattern is chosen
by the CONFigure:WIMax:DLSFrame:PREamble:INDex command according to
the standard.
Example
CONF:WIM:DLSF:PRE:MODE AUTO
Activates the automatic calculation of the preamble index.
Characteristics
RST value: USER
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:DLSFrame:PREamble:INDex
This command specifies the preamble pattern (according to the standard) to be used.
Parameter
integer from 0 to 113
Example
CONF:WIM:DLSF:PMOD USER
Deactivates the automatic calculation of the preamble index.
CONF:WIM:DLSF:PRE:IND 31
Specifies the preamble pattern.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro