R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.799 E-11
C
ONFigure:WIMax:DLSFrame:SEGMent<1…3>
This command specifies the allowable logical subchannel usage of the transmission spectrum
for one of the three downlink PUSC segments.
Note that the indexes specified on the instrument are 0, whereas based under remote control
they are 1 based. This means, the first segment on the instrument is labeled segment 0 and
would be accessed with the command CONF:WIM:DLSF:SEGM1.
Parameter
0 to 63
Example
CONF:WIM:DLSF:SEGM1 63
Specifies the logical subchannel usage of the transmission spectrum for the first downlink PUSC
segment to 63.
Characteristics
RST value: 0
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:FBANd
This command configures the Phase or Frequency vs Preamble measurement type.
Parameter
The suffix 1 can be omitted in the input (see list below) and is omitted in the output (see
example).
Selection Value Range in GHz Description
UNSPecified Unspecified
ETSI or ETSI1 ETSI 3.410–4.200 Licensed Band
ETSI2 ETSI 10.000–10.680 Licensed Band
MMDS or MMDS1 MMDS 2.150–2.162 Licensed Band
MMDS2 MMDS 2.500–2.690 Licensed Band
WCS or WCS1 WCS 2.305–2.320 Licensed Band
WCS2 WCS 2.345–2.360 Licensed Band
CEPT or CEPT1 CEPT 5.470–5.725 License Exempt Band
CEPT2 CEPT 5.725–5.875 License Exempt Band
UNII or UNII1 U–NII 5.250–5.350 License Exempt Band
UNII2 U–NII 5.725–5.825 License Exempt Band
Example
CONF:WIM:FBAN ETSI
Configures the frequency band to be ETSI 3.41GHz – 4.2GHz.
CONF:WIM:FBAN?
After frequency band is set to ETSI this will return "ETSI'' as the current frequency band.
CONF:WIM:FBAN ETSI1
Configures the frequency band to be ETSI 3.41GHz – 4.2GHz.
CONF:WIM:FBAN?
After frequency band is set to ETSI1 this will return "ETSI'' as the current frequency band.
To Next Page
Loading...
