CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.802 E-11
C
ONFigure:WIMax:ULSFrame:FRAMe
This command selects the frame number of the uplink frame in which the UL map that specifies
the uplink burst was transmitted.
Parameter
0 to 10
Example
CONF:WIM:ULSF:FRAM 0
Selects frame number 0.
Characteristics
RST value: 0
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>[:ANALyze]:STATe
This command sets a zone for analysis. This will come into effect when the next measurement
is executed.
Parameter
ON | OFF
Example
CONF:WIM:ZONE1:ANAL ON
Sets zone 1 for analysis.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:CONTrol[:DATA]
This command associates a burst definition with a specific zone. A zone may have up to 32
bursts defined within it.
New bursts can only be appended to the end of the existing burst list. For example if 4 bursts
are already defined, then the suffix required to enter a new burst is 5.
Parameter
<Modulation>,<Subchannels>,<Symbols>,<Slot Duration>,<Subchannel Offset>,<Symbol
Offset>,<Burst Power>,<Burst Type>, with:
<Modulation> QPSK_1_2 | QPSK_3_4 |
QAM16_1_2 | QAM16_3_4 |
QAM64_1_2 | QAM64_2_3 |
QAM64_3_4
modulation scheme
<Subchannels> <numeric_value> number of subchannels used by the burst
<Symbols> <numeric_value> number of symbols used by the burst
<Slot Duration> <numeric_value> slot duration (only applies to uplink and ignored by
downlink bursts)
To Next Page
Loading...
