Rohde & Schwarz R&S FSL3 - Page 1563

CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.804 E-11
C
ONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:FORMat
This command specifies the burst modulation format for the specified zone.
Parameter
QPSK1D2 QPSK code rate 1/2
QPSK3D4 QPSK code rate 3/4
QAM16_1D2 16 QAM code rate 1/2
QAM16_3D4 16 QAM code rate 3/4
QAM64_1D2 64 QAM code rate 1/2
QAM64_2D3 64 QAM code rate 2/3
QAM64_3D4 64 QAM code rate 3/4
Example
CONF:WIM:ZONE1:BURS1:FORM QAM64_3D4
Sets the burst modulation format to QAM64_3D4.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:OFFSet:AUTO
This command allows, for the specified zone and burst, the logical subchannel and symbol
offsets to be automatically calculated so that they are contiguous. The command only applies to
uplink bursts.
Parameter
ON | OFF
Example
CONF:WIM:ZONE1:BURS1:OFFS:AUTO ON
Activates the automatic calculation of the logical subchannel and symbol offsets.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro