Rohde & Schwarz R&S FSL3 - Page 1564

R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.805 E-11
C
ONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:POWer
This command specifies, for the specified zone and burst, the boosting power associated with
the burst.
Parameter
–80 to 10
Example
CONF:WIM:ZONE1:BURS1:POW 0
Sets the boosting power associated with the burst to 0.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:SLOT:DURation
This command defines, for the specified zone and burst, the duration of an uplink burst in slots
in seconds. The command has no effect on downlink bursts.
Parameter
1 to 3000
Example
CONF:WIM:ZONE1:BURS1:SLOT:DUR 10
Sets the duration of uplink burst 1 to 10.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
CONFigure:WIMax:ZONE<1…26>:BURSt<1...32>:SUBChannel:COUNt
This command defines, for the specified zone and burst, the number of logical subchannels
used by the burst.
Parameter
1 to 60
Example
CONF:WIM:ZONE1:BURS1:SUBC:COUN 5
Sets the number of logical subchannels used by burst 1 to 5.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro