R&S FSL FETCh Subsystem (WiMAX, K92/K93)
1300.2519.12 6.819 E-11
FETCh:BURSt:ALL?
This command returns all the results. The results are output as a list of result strings separated
by commas in ASCII format. For details on the format refer to "ASCII formats for returned
values" on page 6.817. The units for the EVM results are specified with the UNIT:EVM
command.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:ALL?
All calculated results are returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
FETCh:BURSt:CINR?
This command returns all the CINR results separated by commas. For details on the format
refer to "ASCII formats for returned values" on page 6.817.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:CINR?
The calculated CINR results from the most recent measurement are returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
FETCh:BURSt:CINR:AVERage? / FETCh:BURSt:CINR:MINimum? /
FETCh:BURSt:CINR:MAXimum?
This command returns the determined CINR (carrier to interference and noise ratio) standard
deviation value (average, minimum or maximum value). The result is returned in ASCII format.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:RSS:MAX?
The calculated maximum CINR value is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
