SENSe Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.842 E-11
[SENSe:]POWer:ACHannel:MODE
This command sets the ACP measurement mode to either absolute or relative.
Parameter
ABS Absolute measurement
REL Relative measurement
Example
POW:ACH:MODE ABS
Sets the ACP measurement to absolute mode.
Characteristics
*RST value: REL
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]
This command defines the channel spacing of the adjacent channel to the TX channel.
Parameter
0 Hz to 100 GHz
Example
POW:ACH:SPAC 33kHz
Sets the spacing between the carrier signal and the adjacent channel to 33 kHz
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
[SENSe:]POWer:ACHannel:SPACing:ALTernate<1|4>
This command defines the channel spacing of the first to fourth alternate adjacent channel to
the TX channel..
Parameter
0 Hz to 100 GHz
Example
POW:ACH:SPAC:ALT1 100kHz
Sets the spacing between TX channel and first alternate adjacent channel to 100 kHz.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
