Rohde & Schwarz R&S FSL3 - Page 1602

R&S FSL SENSe Subsystem (WiMAX, K92/K93)
1300.2519.12 6.843 E-11
[SENSe:]POWer:NCORrection
This command activates or deactivates the noise correction for future spectrum ACP
measurements.
Parameter
ON | OFF
Example
POW:NCOR ON
Activates the noise correction.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
[SENSe:]POWer:SEM:CLASs
This command sets the Spectrum Emission Mask (SEM) power class.
This command is available from firmware version 1.60.
Parameter
0 automatic selection
1 (–INF, 23) dBm for uplink, (–INF, 29) dBm for downlink
2 (23, INF) dBm for uplink, (29, 40) dBm for downlink
3 (40, INF) dBm for downlink
Example
POW:SEM:CLAS 0
Sets the SEM power class to automatic.
Characteristics
RST value: 0
SCPI: device–specific
Mode
WiBro
[SENSe:]POWer:SEM:MODe
This command sets the Spectrum Emission Mask (SEM) analysis to be UL or DL (uplink or
downlink).This command only available for WiBro standard.
Parameter
DL | UL
Example
POW:SEM:MOD UL
Sets the Spectrum Emission Mask analysis to be UL.