SENSe Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.844 E-11
C
haracteristics
RST value: –
SCPI: device–specific
M
ode
WiBro
[SENSe:]POWer:SEM:TTA
This command sets the Spectrum Emission Mask (SEM) analysis according to TTA standard or
a user defined mask.
This command is available from firmware version 1.60.
Parameter
USER | STANDARD
Example
POW:SEM:TTA STANDARD
Sets the SEM analysis according to TTA standard.
Characteristics
RST value: STANDARD
SCPI: device–specific
Mode
WiBro
[SENSe:]SUBChannel
This command sets the subchannel to be used in the measurement. It is only available in Up
Link mode.
Parameter
1 to 31
Example
SUBC 12
Sets the subchannel to 12.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
To Next Page
Loading...
