Rohde & Schwarz R&S FSL3 - Page 1604

R&S FSL SENSe Subsystem (WiMAX, K92/K93)
1300.2519.12 6.845 E-11
[
SENSe:]SUBChannel:STATe
This command enables or disables the use of subchannels in the measurement analysis. It is
only available in Up Link mode.
Parameter
ON | OFF
Example
SUBC:STAT ON
Specifies that the measurement will be analyzed using the specified SUBChannel.
Characteristics
RST value: OFF
SCPI: conform
Mode
OFDMA/WiBro
[SENSe:]SUBChannel:ULPHysmod
This command sets the Up Link Physical Modifier to be used in the measurement. It is only
available in Up Link mode.
Parameter
0 to 255
Example
SUBC:ULPH 1
Sets the UL Physical Modifier to 1.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro
[SENSe:]SWAPiq
This command defines whether or not the recorded IQ pairs should be swapped (I<–>Q) before
being processed.
Parameter
ON | OFF
Example
SWAP ON
Specifies that IQ values should be swapped.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro