Analog Demodulation (Option K7) R&S FSL
1300.2519.12 4.144 E-11
Softkeys of the analog demodulation menu
The following table shows all softkeys available in the analog demodulation menu. It is possible that
your instrument configuration does not provide all softkeys. If a softkey is only available with a special
option, model or (measurement) mode, this information is delivered in the corresponding softkey
description.
Menu / Command Submenu / Command Command
Modulation AM/FM/PM
Result Display AF Time Domain
AF Spectrum
RF Time Domain
RF Spectrum
Select Trace
Diagram Full Size
Demod BW
Meas Time
AF Range Dev per Division/dB per Division
Reference Position
Reference Value
Deviation Lin/Log
Demod Settings AF Coupling AC/DC
AF Filter Low Pass AF Filter
High Pass AF Filter
Deemphasis
Zero Phase Reference Point
Phase Wrap On/Off
Phase Unit Rad/Deg
More
Zoom
Modulation AM/FM/PM
Selects the display of demodulated AM, FM, or PM signal. In single sweep mode, the data is
determined from the current I/Q data set, i.e. a change to AM/FM/PM does not trigger a new
measurement.
If FM is selected, the average value of the demodulated signal is mapped depending on the AF
Coupling AC/DC softkey setting.
Remote: CALC:FEED 'XTIM:FM'
To Next Page
Loading...
