R&S FSL Cable TV Measurements (Option K20)
1300.2519.12 4.241 E-11
Auto Range
Automatically adjusts the x– and y–axis once. Alternatively the range of the y–axis can be
changed via the Range Log softkey or the Range Linear softkey in the amplitude menu.
Remote: DISP:TRAC:Y:AUTO ON
Digital TV
Opens a submenu with all available digital TV measurements. Every measurement type
provides its own submenu to set the parameters. Additionally the Digital TV Settings softkey
gives access to the modulation standard information.
This softkey is only available if the active channel table has at least one channel with a digital TV
modulation standard, or if no channel table < none > is activated.
If an analog TV channel is in use when pressing this softkey, automatically the first digital
channel of the active channel table is selected.
For further details refer also to section "Measurements" on page 4.204.
Spectrum
Opens a submenu to measure a digital TV spectrum.
For further information refer to "Spectrum – digital TV" on page 4.218.
Remote: CONF:DTV:MEAS DSP
Remote: TRAC? TRACE1
Overview
Opens a submenu to measure the modulation accuracy.
For further information refer to "Overview – digital TV" on page 4.219.
Remote: CONF:DTV:MEAS OVER
Remote: CALC:DTV:RES? ALL
Zoom
Opens the Select Result Parameter dialog box to set the zoom:
None
The whole result table is displayed (default setting).
[parameter] The selected parameter is displayed separately in the upper pane.
Remote: DISP:ZOOM:OVER MERP
Remote: DISP:ZOOM:MERR MERP
Modulation Analysis
Opens a submenu to select one of the following modulation measurements:
– Const Diagram
– Modulation Errors
To Next Page
Loading...
