Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.240 E-11
L
ine
Opens an edit dialog box to set the line number of the TV picture. The numbering conventions
depend on the following conditions:
TV standard Color system Field number Line numbering
M
– – 1, 2, …, 625
M
PAL – 1, 2, …, 525
M
NTSC 1 1, 2, …, 263
M
NTSC 2 1, 2, …, 262
Remote: TRIG:VID:LINE 17
Field 1/2
Selects the active field. Field 1 is the default state. This softkey is only available for the TV
standard M in combination with another color system than PAL.
For details on numbering conventions of TV picture lines refer to the Line softkey.
Remote: TRIG:VID:FIEL 2
Sweeptime Manual
Opens an edit dialog box to enter the total sweep time. Possible values are 25, 50 and 100 Ms.
The set value is indicated on the softkey.
Remote: SWE:TIME 10s
Trigger Offset
Opens an edit dialog box to enter a value for the trigger offset. The set value is indicated on the
softkey.
Remote: TRIG:HOLD 500us
Vision Modulation
Opens a submenu to measure the residual picture carrier and the modulation depth.
For further information refer to "Vision Modulation – analog TV" on page 4.217.
Remote: CONF:ATV:MEAS VMOD
Remote: CALC:ATV:RES:VMOD? ALL
Hum
Opens a submenu to measure the hum.
For further information refer to "Hum – analog TV" on page 4.218.
Remote: CONF:ATV:MEAS HUM
Remote: CALC:ATV:RES:HUM?
To Next Page
Loading...
