Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.204 E-11
Tasks
– "To edit a channel table" on page 4.205
– "To create a channel table" on page 4.206
– "To copy a channel table" on page 4.206
– "To create a new modulation standard" on page 4.207
– "To edit a modulation standard" on page 4.208
– "To copy a modulation standard" on page 4.208
– "To perform a measurement using a channel table" on page 4.208
– "To perform a measurement without a channel table" on page 4.209
Measurements overview
All measurements can be performed with or without using a channel table (see also "To perform a
measurement using a channel table" on page 4.208 and "To perform a measurement without a channel
table" on page 4.209). In this section, the measurements are performed using a channel table. For
every measurement type, a short introduction is given. For a more detailed description on every
measurement type refer to chapter "Advanced Measurement Examples".
The measurements are divided into three groups:
analog TV Using an analog modulation standard, the measurement of one single channel is
performed.
digital TV Using a digital modulation standard, the measurement of one single channel is
performed.
TV analyzer Measurements on the entire TV network, i.e. several or all channels, are
performed.
For detailed information on the softkeys provided for each measurement type, refer to "Softkeys of the
measurement menu (Cable TV Analyzer mode)" on page 4.230.
The following measurement types are provided:
• analog TV measurements:
– "Spectrum" on page 4.213
– "Carriers" on page 4.214
– "C/N" on page 4.214
– "CSO" on page 4.215
– "CTB" on page 4.216
– "Video Scope" on page 4.217
– "Vision Modulation" on page 4.217
– "Hum" on page 4.218
To Next Page
Loading...
