Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.208 E-11
8. Press the Save Changes softkey to save the changes.
The new modulation standard can be used for any channel.
9. To discard the changes, press the Discard Changes softkey.
To edit a modulation standard
1. In the Channel Setup – Edit / New / Copy submenu, press the Modulation Options softkey.
In the Modulation Standards dialog box, all modulation standards defined for this channel table
are displayed.
2. In the Modulation Standards dialog box, set the focus on the modulation standard you want to
edit.
3. Press the Edit softkey.
The Modulation Standard Options dialog box is displayed.
4. For further instructions see "To create a new modulation standard" on page 4.207.
To copy a modulation standard
1. Press the Channel Setup softkey.
2. In the Channel Tables dialog box, focus the channel table that contains the modulation standard
you want to copy.
3. Press the Copy softkey (for further details see "To create a channel table" on page 4.206).
4. Enter a name for the copied channel table.
5. If you want to alter the channel table, continue as described in "To edit a channel table" on page
4.205, step 4.
6. If you want to alter the modulation standard, press the Modulation Options softkey and then the
Edit softkey (for further details see "To create a new modulation standard" on page 4.207).
To perform a measurement using a channel table
1. Press the Channel Setup softkey.
The Channel Tables dialog box is displayed.
2. Select the channel table you want to use for the measurement and press the ENTER key or the
Activate softkey.
If no adequate channel table is available, you can edit or create a channel table, or perform the
measurement without a channel table (For details refer to "To edit a channel table" on page 4.205,
"To create a channel table" on page 4.206 or "To perform a measurement without a channel table"
on page 4.209).
3. Press the MEAS key.
4. In the measurement menu, press the softkey for the measurement you want to perform.
5. Set up the measurement as described for every measurement type in section "Measurements" on
page 4.204.
6. Press the RUN key to start the measurement.
To Next Page
Loading...
