R&S FSL Cable TV Measurements (Option K20)
1300.2519.12 4.209 E-11
To perform a measurement without a channel table
1
. Press the Channel Setup softkey.
The Channel Tables dialog box is displayed.
2. Select no channel table < none > and press the ENTER key or the Activate softkey.
3. Press the MEAS key.
4. In the measurement menu, press the Analog TV or Digital TV softkey.
5. Press the softkey for the measurement you want to perform.
6. Press the Analog TV Settings or Digital TV Settings softkey to setup the modulation parameters.
The Analog TV Settings or Digital TV Settings dialog box is displayed.
7. Enter the parameters for the measurement.
– analog TV: for details refer to the Analog TV Settings softkey in the analog TV measurement
menu.
– digital TV: for details refer to the Digital TV Settings softkey in the digital TV measurement
menu.
8. Press the Adjust Attenuation softkey to set the signal level appropriately.
9. Press the RUN key to start the measurement.
Information in the status bar
The status bar provides valuable information for working with the application. The information is
supplied context–sensitively and always refers to the graphical user interface element in focus. The
following types of information are displayed:
• possible range for a parameter
• description what to do
• hints
• warnings
• information on synchronization
To Next Page
Loading...
