Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.232 E-11
Menu /
Command
Submenu /
Command
Submenu / Command Command
More
Channel Power Channel No
Edit Table
Adjust Attenuation
APD Channel No
Scaling x–Axis Signal Lvl
x–Axis Range
y–Axis Max Value
y–Axis Min Value
Default Settings
Adjust Attenuation
CCDF Channel No
Percent Marker
Scaling same contents as in
APD submenu
Adjust Attenuation
Digital TV Settings
TV Analyzer Tilt Tilt Setup
Auto Range
Adjust Attenuation
Analog TV
Opens a submenu with all available analog TV measurements. Every measurement type
provides its own submenu to set the parameters. Additionally the Analog TV Settings softkey
gives access to the modulation standard information.
This softkey is only available if the active channel table has at least one channel with an analog
TV modulation standard, or if no channel table < none > is activated.
If a digital TV channel is in use when pressing this softkey, automatically the first analog channel
of the active channel table is selected.
For further details refer also to section "Measurements" on page 4.204.
Spectrum
Opens a submenu to measure an analog TV spectrum.
For further information refer to "Spectrum – analog TV" on page 4.213.
Remote: CONF:ATV:MEAS ASP
Remote: TRAC? TRACE1
To Next Page
Loading...
