R&S FSL Cable TV Measurements (Option K20)
1300.2519.12 4.245 E-11
Default Settings
For details refer to the Default Settings softkey in the power measurement menu of the base
unit.
CCDF
Opens a submenu to measure the complementary cumulative distribution function (CCDF) of the
amplitude of a digital TV signal sampled in the complex base band.
For further information refer to "CCDF – digital TV" on page 4.222.
Remote: CONF:DTV:MEAS CCDF
Remote: TRAC? TRACE1
Percent Marker
For details refer to the Percent Marker softkey in the power measurement menu of the base
unit.
TV Analyzer
Opens a submenu with all available measurements that can be applied to a set of channels or
all channels of the entire TV network (channel table). In these measurements, both analog and
digital TV channels can be measured together. This softkey is only available if a channel table is
selected.
Every measurement type provides its own submenu to set the parameters. For each
measurement, a channel table must be selected. The choice of no channel table < none > is not
permitted.
For further details refer also to section "Measurements" on page 4.204.
Tilt
Opens a submenu to measure the frequency response of the cable TV system. Each channel is
measured using the information stored in the modulation standard. Channels with the
modulation standard < unused > are not measured.
For further information refer to "Tilt – TV analyzer" on page 4.222.
Remote: CONF:TV:MEAS TILT
Remote: TRAC? TRACE1
To Next Page
Loading...
