3GPP Base Station Measurements (Option K72) R&S FSL
1300.2519.12 4.294 E-11
31 dBm
P < 39 dBm
P
< 31 dBm
The power at the different frequency offsets is compared with the selected limit line.
Remote: CALC:LIM:ESP:MODE MAN
Remote: CALC:LIM:ESP:VAL 39
Limit Line User
Opens the lines menu of the base unit and switches to the standard limit line handling of the
base unit. For details refer to section "Softkeys of the lines menu" on page 4.123 of the base
unit.
Remote: CALC:LIM:ESP:MODE USER
Restore Std Lines
Restores the limit lines defined according to the standard to their factory–set values.
Remote: CALC:LIM:ESP:REST
30kHz/1MHz Transition
Defines the offset frequency at which the resolution bandwidth is changed in the range from 30
kHz to 1 MHz. The default value is 4.0 MHz.
Remote: CALC:LIM:ESP:TRAN 5MHZ
Adjust Ref Level
Adjusts the reference level to the total signal power measured. This softkey becomes active
after the occupied bandwidth has been measured in the first sweep and therefore the total signal
power is known.
This ensures that the signal path is not overdriven and that the dynamic range is not limited by a
reference level that is too low.
Remote: POW:ACH:PRES:RLEV
To Next Page
Loading...
