R&S FSL CDMA2000 BTS Analyzer (Option K82)
1300.2519.12 4.295 E-11
CDMA2000 BTS Analyzer (Option K82)
The R&S FSL equipped with the CDMA2000 BTS Analyzer option performs Code Domain
measurements on forward link signals according to the 3GPP2 Standard (Third Generation Partnership
Project 2). The "Recommended Minimum Performance Standard for CDMA2000 Spread Spectrum
Base Stations", C.S0010–C version 2.0 dated March 2006, is taken as a basis. This Standard has been
approved by the following authority with the specified designation:
• TIA: TIA-97-F-1
• TTA: TTAT.3G-C-S0010-C v2.0
When the CDMA2000 specification is mentioned in the document, these standards are meant.
The CDMA2000 BTS Analyzer option supports the radio configurations 1 to 5, i.e. all radio
configurations with a single carrier (1X) are supported. Accordingly, IS95A/B signals conforming to radio
configurations 1&2 can be measured with the CDMA2000 BTS Analyzer option. In addition to the
measurements called for by the CDMA2000 standard in the code domain, the CDMA2000 BTS
Analyzer option features measurements in the spectral range such as channel power, adjacent channel
power, occupied bandwidth and spectrum emission mask with predefined settings.
This option is available from firmware version 1.90.
To open the CDMA2000 BTS Analyzer
If the CDMA2000 BTS Analyzer mode is not the active measurement mode, press the MODE key
and activate the CDMA2000 BTS Analyzer option.
If the CDMA2000 BTS Analyzer mode is already active, press the MENU key.
The Code Domain Analyzer menu is displayed. .
Menu and softkey description
– "Softkeys of the Code Domain Analyzer menu (CDMA2000 BTS Analyzer mode)" on page 4.307
– "Softkeys of the frequency menu (CDMA2000 BTS Analyzer mode)" on page 4.335
– "Softkeys of the span menu (CDMA2000 BTS Analyzer mode)" on page 4.336
– "Softkeys of the amplitude menu (CDMA2000 BTS Analyzer mode)" on page 4.337
– "Softkeys of the bandwidth menu (CDMA2000 BTS Analyzer mode)" on page 4.339
– "Softkeys of the sweep menu (CDMA2000 BTS Analyzer mode)" on page 4.340
– "Softkeys of the trigger menu (CDMA2000 BTS Analyzer mode)" on page 4.341
– "Softkeys of the trace menu (CDMA2000 BTS Analyzer mode)" on page 4.341
– "Softkeys of the marker menu (CDMA2000 BTS Analyzer mode)" on page 4.343
– "Softkeys of the marker–> menu (CDMA2000 BTS Analyzer mode)" on page 4.344
– "Softkeys of the measurement menu (CDMA2000 BTS Analyzer mode)" on page 4.345
The lines menu is not available in the CDMA2000 BTS Analyzer mode.
The span menu is not available for code domain measurements and signal power measurements. For
details refer to the corresponding menu descriptions of the base unit ("Setting the Frequency Span –
SPAN Key".
The bandwidth menu is not available for code domain measurements and CCDF measurements. For
details refer to the corresponding menu descriptions of the base unit ("Setting the Bandwidths and
Sweep Time – BW Key").
To Next Page
Loading...
